Can the E-Track Cargo Control # E19148 be Mounted at Different Heights

Question

Question:

at what height do you mount the e-track?

asked by: Rodney G

1

Helpful Expert Reply:

The E-Track can be mounted at any height that you need. I have attached a photo that was submitted by one of our customers with the tracks at different heights on his trailer for you to check out. For the best support, I recommend attaching the E-Tracks to as many frame supports as possible in the walls or on the floor.

You may also be interested in the E-Track Plastic End Cap, # ET8730, to cover the metal edges at the ends of the tracks.

expert reply by: John H

1

click to enlarge

Answer 1

There isn't a specific height from the trailer floor recommended to mount the E-Track. My gut feeling is that if 3 feet is too low and 4 feet is too high then 3-1/2 feet might be perfect. Another option is to mount E-track pieces vertically along…

view full answer...

Answer 2

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 3

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 4

E-tracks are typically the stronger of the two, but X-track is more versatile since you can mount them horizontally or vertically. Choosing between the two really depends upon how you plan to use them. If you are installing something in a truck bed,…

view full answer...

Answer 5

Since the slot dimensions and capacity of different brands of E-Track are identical, really the only differences are the finish and the lengths the tracks are sold in. If you're using the E-Track in an area where aesthetics are important, you can…

view full answer...

Answer 6

No long-term contract, Natalie - but a service plan is required to use the trackers. When you buy the 3000 with wifi assist #PM84FR, 5000 #PM64FR, or 5000 with wifi assist #PM74FR from etrailer, you’re purchasing the hardware/device only. To activate…

view full answer...

Answer 7

Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…

view full answer...

Answer 8

Having the factory fuse is perfectly fine for an aftermarket brake controller. The benefit of a circuit breaker is that it can reset itself so you do not have to replace a fuse should it blow. So you are good to go with the 30 amp factory fuse…

view full answer...

Answer 9

Yes, you can use Erickson Horizontal E-Track item #E19148 as front straps to hold down a car. These tracks have a 2,000 lbs maximum capacity per track. You will want to use the etrailer E-Track Backing Plates w/ Hardware item #e96RR for mounting. The…

view full answer...

Answer 10

The Erickson E-Track is very versatile so they isn't a specific size or model for your 5 x 8 Haulmark Transport Deluxe Cargo Trailer, just install as much or as little as you want, on the deck or on the wall. I have included a link to all of the…

view full answer...

Can the E-Track Cargo Control # E19148 be Mounted at Different Heights

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching