Is a Dutchmen Coleman Rubicon Setup for Crossbars from the Factory

Question

Question:

Are there cheaper options that you trust? I already have the aero bars from Yakima so really just need the side rails to compete the package.

asked by: Mark

1

Helpful Expert Reply:

I do have options for you but I don't have any information that the Dutchmen Coleman Rubicon comes equipped with a factory rack. That said, it would be pretty easy to add one using a kit like the Yakima Aero Bar Roof Rack for Camper Shells part # Y67CV. This kit installs via tracks which get bolted to the roof and then provides you with adjustable crossbars to secure your gear.

expert reply by: Conner L

1

Mark

12/14/2022

Are there cheaper options that you trust? I already have the aero bars from Yakima so really just need the side rails to compete the package.

Reply

Conner L.

12/14/2022

If you already have Yakima Aero Crossbars then you'd just need the following to complete your setup. Yakima 60" Tracks part # Y01135 Yakima SkyLine Towers part # Y53TR Yakima Landing Pad 1 part # Y00221 (2)

Reply

Answer 1

Hey Cathy, sweet camper! I really like the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-500B-ST you were looking at because it's a tried-and-true solution that also gives you tracks so you can accommodate a variety of different load…

view full answer...

Answer 2

I was able to find some good pictures of your 2023 Dutchmen Coleman Rubicon 1400BH and it looks like you have ST215/75R14 tires on there. Check the sidewall of the tire to verify this is the correct size. This means you have 14" wheels. I can…

view full answer...

Answer 3

You will have to run the wire from the battery to the 1 o'clock terminal on the 7-way connector in the 7-Way RV Upgrade Kit #ETBC7L. This wire is what powers the Curt Echo Wireless Trailer Brake Controller #C51180 and allows you to have trailer…

view full answer...

Answer 4

From what I could find it looks like your ADTH 1RV-200 motor has a weight capacity of 6,500 lbs. You can use a motor that is rated for a higher capacity, like our replacement motor #LC142178 for Ram landing gear which is rated at 8,000 lbs. Just keep…

view full answer...

Answer 5

I do have an option for you but roof rails won't work very well on a teardrop trailer, even if you were able to get the rails to conform, it's likely the accessories would bind due to the steep angles. Instead, you will need to use artificial…

view full answer...

Answer 6

We do have the correct replacement for your Atwood 71119 landing gear motor, which is what is shown in your photo. The replacement part is the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor #LC141893. I have added a link to a…

view full answer...

Answer 7

The 2022 Ford F-53 does not have a custom fit brake controller wiring harness available for it yet so you'd need to cut off the connector and wire it to the controller. I attached a picture of what the harness looks like though.

view full answer...

Answer 8

To install the Redarc Tow-Pro Liberty Brake Controller item #RED24FR in your 2019 Toyota Tacoma all you will need is the Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR. I have attached a couple of pictures…

view full answer...

Answer 9

For your 2015 Itasca Viva 24b with 2 inch hitch receiver, I recommend the Curt Trailer Hitch Mounted Spare Tire Carrier #C31006. I recommend using a hitch lock like #e98880 and the etrailer.com Spare Tire Lock #e98892 to secure your tire and…

view full answer...

Answer 10

You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same…

view full answer...

Answer 11

The biggest pro to using one valve stem to maintain air pressure in an air bag kit is that you always know that both bags will have an equal amount of pressure in them. If you have an application where equal pressure on both sides is always the norm…

view full answer...

Answer 12

To install a union tee for the Firestone Ride-Rite Air Helper Springs #F2410 on your 2019 Toyota Tacoma you will need the 1/4" #F3025-1. You can certainly do this on your truck to allow you to fill up the bags at the same time. The only…

view full answer...

Is a Dutchmen Coleman Rubicon Setup for Crossbars from the Factory

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching