Does The Hott Rod RV Water Heater Conversion Kit Heating Element Need Removed For Draining?

Question

Question:

I think this will go where my drain plug is located. After installing it, how do I drain the tank? It will take too many rotations for twisting stress of the cable. Do you install a valve and it between the tank and HottRod? I dont think there is room for that. Thanks

asked by: Phil A

0

Expert Reply:

The cable for the Hott Rod RV Water Heater Conversion Kit # DGR6VP is removable from the Heating Element # DGR6P2PB. You will simply pull the end of the cable off the heating element when you need to remove it for draining your water heater.

expert reply by: Bud M

0

Answer 1

I have a solution for you, but we do not offer a fully electric option hot water heater for RVs. If you have an Atwood, Suburban, American, or Moreflow hot water heater, you can use the Hott Rod RV Water Heater Conversion Kit #DGR6VP (6 gallon…

view full answer...

Answer 2

The correct Hott Rod RV Water Heater Conversion Kit for a 6 gallon water heater is part #DGR6VP, the part #DGR10VP is for 10 gallon water heaters and would be too powerful for a 6 gallon.

view full answer...

Answer 3

Hello Oscar, thanks for reaching out. We have exactly what you are looking for. The 30153 you mentioned are universal industry standard 5th wheel base rails. We sell this exact rail set as part #RP30153. This comes with both rails, and all of the…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

To know if your 2017 Ford F-350 has an in-bed puck system installed you'll just need to look and see if you have four rounded attachment points (usually covered up when not in use, like in the attached picture). If you don't see these in your…

view full answer...

Answer 6

I confirmed with Diamond Group that the Hott Rod RV Water Heater Conversion Kit - Propane to Electric #DGR6VP needs a 15-amp circuit breaker. As far as the wiring for the Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water…

view full answer...

Answer 7

The only replacement part available for the Hott Rod RV Water Heater Conversion Kit - Propane to Electric - 400 Watt - 6 Gallon #DGR6VP is the heating element #DGR6P2PB. Unfortunately, this means that the only option for a replacement cord with the…

view full answer...

Answer 8

The tank mounted thermostat with the Hott Rod RV Water Heater Conversion Kit #DGR6VP allows you to set the temperature for the tank. This thermostat must be mounted to the tank. It is simply plugged in and out of the outlet unless you you prefer to…

view full answer...

Answer 9

When turning your Atwood/Dometic G6A-8E water heater from propane to electric you will need The Hott Rod RV Water Heater Conversion Kit #DGR6VP. This conversion kit converts your RV's propane water heater to electric operation, while keeping your…

view full answer...

Answer 10

For a 6 gallon Atwood water heater that's propane powered the kit you'd need to convert to electric is the Hott Rod RV Water Heater Conversion Kit #DGR6VP.

view full answer...

Answer 11

It will indeed. The #DGR6VP Hott Rod RV Water Heater Propane to Electric Conversion Kit is compatible with Atwood, Suburban, American, and Moreflow water heaters with 6 gallon tanks. Dometic bought out Atwood, so their water heaters are identical. If…

view full answer...

Does The Hott Rod RV Water Heater Conversion Kit Heating Element Need Removed For Draining?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching