Ball Mount For My Class 2 1-1/4 Inch Hitch
Published 09/01/2022
Products Featured in This Question
Question:
1.24 class 1 reciever extender. I do not want 1.24 to 2 I only want to move the ball away from my plastic bumper yet I find no listing for such an item. Will I need to make my own?
asked by: Raymond L
Expert Reply:
The Curt Class II Drawbar # C45016 will move the hitch ball away from your plastic bumper. Using this drawbar will move the hitch out 9-3/8 inches which is center of hitch pin hole to center of hitch pin hole.
The ball mount has a sturdy steel construction which has a black gloss powder coat finish. The ball mount has a gross towing weight up to 3,500 pounds and a tongue weight up to 350 pounds.
I attached a review video link below.
Product Page this Question was Asked From
Curt Hitch Extender for 1-1/4" Trailer Hitch Receivers - 7" Long
- Hitch Adapters
- Hitch Extender
- Bike Racks
- Cargo Carriers
- Hitch Mounted Accessories
- Trailers
- 7 Inch Extension
- Fits 1-1/4 Inch Hitch
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will The ShakeStopper Bumper Hitch MNT72VR Work For Carrying Two Electric Bikes?
- Q&A: What is Difference Between two Hitches that Fit 2019 Toyota Highlander
- Q&A: Best Trailer Hitch For 2022 Lexus RX450HL That Will Not Obstruct Rear Kick Sensor
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Q&A: Stabilizer Kit for 32K Gen-Y Adjustable 2-Ball Mount w/ 2-1/2" Stacked Receivers
- Q&A: Will Fulton Fold-Away Coupler Hinge Kit Work to Add 24" Extension to Boat Trailer?
- Q&A: Compatibility Of 1-1/4 to 2 Hitch Adapter On a 2021 Volvo XC60 With Class I Receiver