Using Nylon Lock Nuts On 2 Inch Square Trailer U-Bolt SP01-160
Updated 11/15/2013 | Published 11/13/2013
Question:
What do you think about using a set of SS nylon lock nuts rather than nuts supplied? Thanks
asked by: David P
0
Expert Reply:
For the 2 inch Square Trailer U-Bolt, part # SP01-160 you purchased, you can use nylon lock nuts that would work for a 9/16 bolt.You would want to make sure you use nuts of equal strength and that they match the thread and size.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
2" Square Trailer U-Bolt (Qty 2)
- Trailer Suspension Parts
- U-Bolts
- Camper
- Car Hauler
- Utility Trailer
- 3500 lbs
- Square Axle - 2 Inch
- 9/16 Inch Diameter
- 5-3/4 Inch Long
- Redline
more information >
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Best Way To Find Replacement Parts For 1999 EZ-Loader Boat Trailer
- Q&A: What Is The Span Or Usable Length Of RV Designer Hitch Pin - 1/2" # RD83GR
- Q&A: Correct Replacement for 26-1/2 Long Leaf Spring
- Q&A: How To Flip Square Trailer Axle For Ground Clearance
- Q&A: Replacement Reservoir Tank for Lippert Hydraulic Power Slide Out Unit
- Q&A: What Is Needed To Swap An Axle And Hubs To American Parts On A Harbor Freight Trailer?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What is the Spacing Between the Front Hanger and Rear Hanger for 27" Leaf Spring Single Axle Trailer
- Article: Trailer Tire Sizing
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Ram Trailer Tow Prep Package
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle