Replacement for Venture M-9000 PK Landing Gear Motor

Question

Question:

I have a m 9000 pk landing gear motor but want something stronger what do you suggest

asked by: Dave

0

Expert Reply:

The correct replacement for a Venture M-9000 PK Landing Gear Motor is the Lippert Venture 5th Wheel RV Landing Gear Motor part # LC142178 or you can upgrade to the Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor part # LC196308 which has a higher capacity.

expert reply by: Conner L

0

Answer 1

We have just what you need to replace your landing gear motor M9000PK with the #LC196308 and you'd be set! This is a confirmed fit for what you have and is a faster motor too so your jacks will raise and lower quicker.

view full answer...

Answer 2

There are a few things to look at that could be your issue. Since your batteries are fully charged, I would suggest looking at it piece by piece. To get you proper parts, I need to know the manufacturer of the landing gear and any info about the…

view full answer...

Answer 3

Any powered landing gear or powered tongue jack will draw less power as it legs descend down toward the ground and much more as soon as they make contact and encounter resistance. This is a normal occurrence. In the same way, any jack - even a manual…

view full answer...

Answer 4

The end of the Replacement Manual Crank Handle #LC119226 is a slotted cylinder which means there isn't a socket that would work as a substitute.

view full answer...

Answer 5

The replacement motor for your Lippert Venture VMC940RB would be the Replacement Motor for Stromberg Carlson Electric Landing Gear Set #LC196308. The Replacement Gearbox #LC276602 is correct too if you needed that as well.

view full answer...

Answer 6

To replace the Venture VMC940RB-135558 gearbox on your trailer's landing gear system, you will just need the Replacement Gearbox #LC276602. This gearbox features a corrosion resistant aluminum construction and will perfectly replace your…

view full answer...

Answer 7

It could be the motor but it could also be the screw/nut inside the jack leg that is causing the problem. Since you mentioned that it is hard to crank it manually I suspect that it is likely the screw and/or nut. On jacks that have an ACME screw the…

view full answer...

Answer 8

To replace your existing Venture motor, the Lippert Components Venture 5th Wheel RV Landing Gear Motor #LC142178 is the correct replacement part for you. For an aluminum gear box, you are correct that you can use part #LG-179015. The #LC142178 motor…

view full answer...

Answer 9

The weld stops on the legs of Stromberg-Carlson landing gear set #LG-1 are indeed 17-1/2 inches measured from the top of the top one to the bottom of the bottom one. If you look at the diagram I have included you will see that they have measured from…

view full answer...

Answer 10

While I'm not Rachel, I can tell you a compatible replacement for your landing gear motor MQ887 is the following part: - Replacement Motor for Stromberg Carlson Electric Landing Gear #LG-142178

view full answer...

Answer 11

The correct replacement for your Venture VMC900R RV landing gear are part #LC119102 for the lead leg or #LC119101 for the follow leg. These will be direct replacements for the current legs you've got.

view full answer...

Answer 12

If the thrust bearing is broken on your VMC900R Venture landing gear you are going to need to replace the leg, which you would need to match by the length of the outer tube, which is likely going to be 29-1/2 inches, but please measure to verify.…

view full answer...

Replacement for Venture M-9000 PK Landing Gear Motor

Products Featured in This Question

Continue Researching