Maximum Wire Gauge/Size That Fits Pollak Heavy-Duty 4-Pole Round Pin Trailer Connector # PK11409
Updated 11/14/2013 | Published 11/12/2013 >
Question:
What is the maximum wire size that can be connected to this connector. Will it accept a AWG 8, or is AWG 10 the max. What size, in mm, is the wire receptacle. Thanks
asked by: Neal R
Expert Reply:
The Pollak Heavy-Duty 4-Pole Round Pin Trailer Connector # PK11409 will accept wire up to 12-gauge according to my technical contact at Pollak. This connector is rated for up to 24 volts at 20 amps current.
I did pull a piece from inventory to measure the size of the receptacles for the wires. I used a precision digital caliper to measure the size of the holes. These measured 2.8mm in diameter.
Product Page this Question was Asked From
Pollak Heavy-Duty, 4-Pole, Round Pin Trailer Wiring Connector - Chrome - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 4 Round
- Plug Only
- Pollak
more information >
Continue Researching
- Q&A: Replacement Inner Member for TDE LP8500 Actuator
- Q&A: Replacement Hubs And Electric Brakes For Dexter axle 8-133
- Q&A: Direct Replacement Water Heater for Atwood Model GC10A-4E
- Q&A: Replacement Hub/Drum For Lippert Hub Stamped 122093
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Do The Furrion Chill Cube AC Units Have A Soft Start Installed?
- Q&A: How to Wire 4-Way Round Pin Trailer Wiring Connector PK11409
- Q&A: Recommended Flat Towing System for a 2010-2012 Dodge Ram 1500
- Article: Must-Have Flat Towing Components
- Article: Best RV Roof Vents
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop

