How Does LED Clearance Light part # MCL0030ABB Install
Published 08/18/2022
Question:
How are they mounted? Is the front lens removable?
asked by: MG C
0
Expert Reply:
To mount the LED Clearance Light part # MCL0030ABB you would need to pry off the lens using the slots on the bottom of the lens and then use the mounting holes that are behind the lens through the base of the light.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Oval - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Oval
- Surface Mount
- Non-Submersible Lights
- LED Light
- 3-3/4L x 1-13/16W Inch
- Amber
- Optronics
more information >
Continue Researching
- Shop: LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Oval - Amber Lens
- Q&A: Replacement Clearance Lights For Glo Brite 122r/122y
- Q&A: Is There a Replacement Lens for Winnebago 147680-02-01A (Glo-Brite 122Y) Amber Marker Light
- Q&A: What Is the Measurement of the Bolt Holes on the SeaFlo Battery Disconnect?
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: Help Identifying Trailer Parts
- Q&A: How Much Does EcoHitch Hidden Front Mount Trailer Hitch Weigh
- Q&A: Troubleshooting Toy Hauler With Rear Axle Measuring About 1/2" Longer Than The Front Axle
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Lighting Requirements
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks