Troubleshooting 2 Wire Trailer Taillights That Dont Work Installed in Place of Single Wire Lights
Published 08/16/2022 >
Question:
I replaced my old tail lights on boat trailer with 2 wire led lights, now the side markers don’t work at all. Please advise, thank you:
asked by: Mark
Expert Reply:
If you had single wire trailer taillights initially that meant that the assemblies grounded through the mounting hardware. If you went to a two wire light that would mean you would actually have to ground each of the assemblies using the white wire of them. You can run them back to the mounting hardware of the lights or you can run them to the main ground harness of your trailer and they should work again. You might also check to make sure that the main ground of your trailer didn't get disconnected either.
Product Page this Question was Asked From
Thinline LED Trailer Clearance or Side Marker Light w/ Bracket - Submersible - 3 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 4L x 1W Inch
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Will Self-Contained Hydraulic Jack Fit Maxx-D DTX 16k Dump Trailer
- Q&A: Replacement Trailer Clearance Light for GloBrite 1250
- Q&A: 16 x 6 Dually Wheels with 4.88 Pilot Hole and 8 on 6-1/2 Bolt Pattern
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Replacement Fireplace for a Furrion FF40SC15ABL
- Article: Trailer Lighting Requirements
- Q&A: Recommended Center Cap for a Aluminum AM03 Series Black Machined Trailer Wheel
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Winch Mounting Plate Needed for Aluma 82 Series Car Hauler Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Fix a Bad Trailer Ground
- Article: Trailer Maintenance Schedule

