Can Trailer Tail Light Mounting Bracket # A66PB Be Installed Upside Down
Updated 10/21/2013 | Published 10/20/2013
Question:
Is there a top and bottom to this bracket? It looks like there may be notches or weep holes on one side of the bracket. The reason I ask is that based on where I am seeing the wire it looks like its at the end of the bracket. I may need flip the bracket over to be able to place the wire where I need it to go through the trailer, does that make sense?
asked by: Terry
Expert Reply:
Mounting bracket # A66PB can be oriented however you would like. There is no top or bottom. If, during installation, you determine that you need to flip it 180 degrees there should be no problem doing so.
Product Page this Question was Asked From
Gray Bracket and Single Wire Plug for Thin Line Series Trailer Clearance and Side Marker Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Gray
- Optronics
more information >
Continue Researching
- Q&A: Is It Ok To Replace 15" x 6" Wheel with 15" x 5" Wheel?
- Q&A: Can a 15x5 Wheel Size Interchange with a 15x6 Wheel Size on a 1995 Mallard Travel Trailer
- Q&A: Replacement Fender Light With Part Number 1A-V-1260AR
- Q&A: Side Wall Vent Recommendation for an Enclosed Trailer for Maximum Air Flow
- Q&A: Are Husky Products Made In The United States?
- Q&A: Replacement Dressing Room Locks for Featherlite Horse Trailer
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: How To Convert Trailer With Slipper Springs To Double Eye Springs
- Article: Most Popular Wheel Bearings
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements