Troubleshooting The Roadmaster EvenBrake That Will Not Sync To Monitor And Fails Test
Updated 07/08/2022 | Published 07/06/2022
Products Featured in This Question
Question:
when trying to sync transmitter and monitor, the even brake only depresses brake arm twice and test light stays red. manual states it should cycle 3 times. any ideas as to what I should try. Monitor say even brake testing and only way to clear the message is to unplug. All wiring is hooked up correctly and I have 12v when it depresses the brake pedal. Is there a process or something I’m missing?
asked by: Ken H
Expert Reply:
I spoke with Roadmaster about this, and they said that the Roadmaster EvenBrake # RM-9410 is looking for voltage from both the EvenBrake & the ICX box, the programming, the brake away sway, & the dinghy vehicles brake switch.
If it is missing any of the checks, then it'll fail the test.
So, the first important thing to check is the signal that should be coming from the brake switch in the vehicle. This wire is connected to the # 1 spade terminal (shown in diagram) on the ICX. This should show voltage every time the brake pedal is depressed in the dinghy vehicle.
You can use a multimeter # PT29ZR to aid in this first troubleshooting step.
I have also attached a wiring diagram supplied by Roadmaster in regards to this issue. This is the first thing you need to check before we can move on to more in depth troubleshooting.
(click to enlarge)
Product Page this Question was Asked From
Replacement Receiver for the Roadmaster Even Brake Braking Monitor
- Accessories and Parts
- Flat Tow Brake System
- Brake Monitoring
- Transmitters
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does the Roadmaster Universal Brake Monitor Come with an Actuator Arm
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Q&A: Do You Need to Have the RF Controller for Blue Ox Patriot 2 & Patriot 3 Supplemental Braking Systems
- Q&A: Replacement RF Controller for Blue Ox Patriot II or Patriot 3 Flat Tow Brake System
- Q&A: Does Breakaway System for Flat Tow Supplemental Braking Need to be Added Separately
- Q&A: 2014 Honda CR-V Flat Towing Preparation Steps
- Q&A: Will The New Replacement Command Center Hub for Curt RVi Series 4 Work on a Series 3
- Q&A: Can Just Motor Home Monitor Be Replaced for Roadmaster Even Brake System
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: RV-Mounted vs Vehicle-Mounted Tow Bars
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2016-2018 Ford Focus
- Article: How to Measure for Trailer Hitch Drop