Do the Load Resistors in the Load Resistor Kit for LED Turn Signals Have + and - Markings
Published 06/24/2022
Question:
Does the load resisters have a + and - ends?
asked by: Oswaldo P
0
Expert Reply:
No, there is not a positive (+) and negative (-) on the ends of the Load Resistor Kit for LED Turn Signals # DI34ZR. It does not matter which side connects to the positive and which to the ground.
I have included a couple wiring diagrams you can check out to help with installation.
expert reply by:
Scott S
0
Installation Diagram of Load Resistor Kit for LED Turn Signals
(click to enlarge)
(click to enlarge)
Installation Diagram of Load Resistor Kit for LED Turn Signals
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How Do I Clear the Bulb Out Indicator After Installing a Flat Bed?
- Q&A: Looking For 18" Long 4-Flat Trailer Extension
- Article: Trailer Wiring Diagrams
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Q&A: Adapter to Allow LED Trailer Wiring to Connect to 2019 Ford F-150
- Q&A: Troubleshooting Hyper Flashing Trailer Lights on Mercedes-Benz Sprinter Van
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer