Replacement For 290 01 J Propane Regulator

Question

Question:

What regulator can I get that compares to this 290 01 J regulator

asked by: Celeste

0

Expert Reply:

To replace your 290 01 J propane regulator you can use the following from Camco:

- Camco Horizontal 2-Stage Propane Regulator - 160,000 Btu/Hr # CAM59323

expert reply by: Kyle S

0

Answer 1

Since your Marshall Gas Controls Model 290-00 is just a standard 2 stage regulator, you can just use the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L #CAM59333 as a replacement. From the picture it does look like you have enough room, but…

view full answer...

Answer 2

Hey Kevin, to replace your Marshall 290-1 regulator you can use the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L #CAM59333 or you can use the #CAM59313 for a vertical regulator replacement. Both of these regulators are 2 stage, rated for…

view full answer...

Answer 3

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 4

Thanks for the picture! To replace your Marshal 605H propane regulator you will need to go with the Camco Vertical 2-Stage Propane Regulator #CAM59313. This will be an exact replacement for your current regulator. I included a video review of the…

view full answer...

Answer 5

Thanks for the pictures, Donny. I didn't see a measurement for the outer bearing but I think we can still put this together based on everything else. It looks like that spindle has a 2.25" ID grease seal with a 1.75" ID inner bearing.…

view full answer...

Answer 6

Yes, this will work for your needs as the Horizontal Low Pressure 2-Stage RV LP Gas Regulator, #37207-30385 is designed to operate in the 9" to 11" W.C. range. You may want to also consider the Horizontal RV LP Gas Regulator Cover,…

view full answer...

Answer 7

The MB Sturgis Propane Adapter Hose - 3/8" Male NPT x 1/2" Female Flare Swivel uses a 3/8" fitting on the regulator side and 1/2" fitting on the manifold side. These are nominal fitting sizes so they don't actually measure…

view full answer...

Answer 8

Hi Bill; since you're running to a single appliance you can use the JR Products RV LP Gas Manifold - 3 Port #JR45CR. You will also need #JR52CR or #JR32CR to make the connections along with the JR Products RV LP Gas Manifold Hose Disconnect Tool…

view full answer...

Replacement For 290 01 J Propane Regulator

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching