What is Thread Size of Ultra-Fab Gooseneck Trailer Tripod Stabilizer
Published 06/22/2022
Question:
Is there a size or a replacement for the nut that the Goose neck ball screws into the stabilizer legs?
asked by: Ginger D
0
Expert Reply:
While we do not carry a replacement nut for the Ultra-Fab Gooseneck Trailer Tripod Stabilizer, # UF19-950450, you should be able to easily source one locally from a hardware store. The thread size is Metric M31-3.5.
expert reply by:
Michael R
0
Product Page this Question was Asked From
Ultra-Fab Gooseneck Trailer Tripod Stabilizer - Steel - 31" to 54" - 5,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Tripod Jacks
- Steel
- 4001 - 5000 lbs
- Manual Jack
- 1 Jack
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Gooseneck Tripod Trailer Stabilizer Recommendation with Height that is at Least 58 inches
- Q&A: Will B and W Fifth Wheel to Gooseneck Adapter Void Lippert Frame Warranty
- Q&A: Which B&W 5th Wheel to Gooseneck Pin Box For A 2023 Forest River Sabre 37FLL?
- Q&A: Can MORryde I-Beam Stabilizer Install on Camper with Underbelly Cover
- Q&A: Is the Andersen Ultimate Connection 5th Wheel Trailer Hitch Compatible w/a B&W Turnover Ball Hitch?
- Q&A: Will Replacement Front Jack for Lippert Ground Control 3.0 System Work On 2021 Open Range 5th Wheel?
- Q&A: Looking for Other Colors of TeraPump UtilityCan with Fuel Transfer Pump
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps