D-Ring Size For Bulldog Winch Ratcheting Wheel Tie-Down Strap
Updated 06/13/2022 | Published 06/11/2022
Products Featured in This Question
Question:
What size D Ring is recommended to accommodate the stamped steel hooks and clasp that this strap uses?
asked by: Michael P
0
Expert Reply:
I recommend using 1/4" or 1/2" D-rings with the Bulldog Winch Ratcheting Wheel Tie-Down Strap for Oversize Spare Tire - Horizontal Mount - 2,000 lbs # BDW20363.
You can use the Brophy Swiveling D-Ring Anchor w Backing Plate and Hardware - Bolt-On - Recessed Mount - 2,000 lbs # RR6K or Brophy D-Ring Tie Down Anchor - Bolt On - 1/2" Diameter - 2,000 lbs # DR01 with Backing Plate # BP1D.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Backing Plate for Brophy D-Ring Tie Down Anchor - Black Powder Coat - Qty 1
- Accessories and Parts
- Trailer Tie Down Anchors
- D-Ring Backing Plates
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Should I Use Bias Or Radial Tires On My Utility Trailer?
- Q&A: Thread Size on CargoSmart Eye Bolt Tie-Down Anchors
- Q&A: What Type of Hardware Should be Used to Install Brophy Rope D-Ring Tie-Down Anchor # SS15-C
- Q&A: What Is The Recommended Lug Nut Torque On 7,000lb Axles?
- Q&A: Keyed Alike Hitch Pin Lock for Replacement Shank for Gen-Y Adjustable Ball Mount 325-GH-306
- Q&A: 10k Tow Loop Needed With Minimal Play In The Receiver Tube
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Article: Trailer Lighting Requirements