Which Grease Caps for a 1987 Coleman Sequoria Pop-Up Camper
Updated 09/25/2009 | Published 09/24/2009
Question:
what size grease caps does this camper need? it has stock 12 in. wheels and stock hubs. thank you for any help received.
asked by: Robert W
0
Expert Reply:
You will need to measure the inside diameter (ID) of the cap mounting surface on your hub to match the outside diameter (OD) of the grease cap. You will then be able to select the proper style cap with the proper OD for your trailer hub.
You can also find the correct grease cap if you can find the hub assembly part number or the bearing part numbers, inner and outer. the grease seal part number would help also.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Grease Cap, 2.44" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 2.44 Inch O.D.
- 2.44 Inch
- 5200 lbs Axle
- 6000 lbs Axle
- TruRyde
more information >
Continue Researching
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Q&A: Can Onan Generator - QG 7000i Use Remote Start
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Adjusting Dexter 10K Electric Trailer Brakes
- Q&A: How Heavy Are Thomas Payne Rest Easy Loveseats? Is It Easy To Move It Into A 5th Wheel RV?
- Q&A: Replacement Grease Seals for Dexter Part # 010-036-00 on a 7,000lb Trailer Axle
- Q&A: Installing Trailer Brake Controller on 2014 Chevy 4500 Chassis
- Q&A: How Much Does the Thomas Payne Dual Reclining RV Loveseat Weigh?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: How to Replace a Rubber RV Roof