What are the Inner Diameters of the Bearings Used in Trailer Hub # 845475UC1
Updated 09/18/2013 | Published 09/17/2013
Products Featured in This Question
Question:
will these bearings fit on a 1 1/16 outter and 1 3/8 inter spindle
asked by: Charlie
Expert Reply:
Bearings have very precise measurements, to the thousandth inch. The hub # 845475UC1 uses inner bearing # L68149. It has an inner diameter of 1.378 inches. The outer bearing is # L44649 and has an inner diameter of 1.063 inches.
While you could convert the measurements to fractions and it would be close to what you have the best way to determine the correct bearings is to go by the old bearing numbers stamped into the metal of the bearings or to get precise spindle measurements using dial or digital calipers.
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-3/4 - Pre-Greased
- Trailer Hubs and Drums
- Idler Hub
- Standard
- L68149 / L44649
- Standard Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-3/4 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Replacement Trailer Hub Assembly for Dexter 8-248 Hubs
- Q&A: Replacement Tail Lights for a 2008 Featherlite 4926 Car Hauler Trailer
- Q&A: Replacement Hub for Utility Trailer with Dexter 8-256 Hub
- Q&A: Recommended Non-Brake Replacement for Dexter 8-243 Hub/Drum
- Q&A: Best Trailer Brakes for a 3,500 Lb Axle
- Q&A: Replacing The Zerk Fitting On A Dexter EZ-Lube Trailer Axle
- Q&A: Correct 4-Way Wiring Harness for 2025 Kia Sorento Hybrid SX Prestige
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Choose the Right Trailer Hitch Class
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)