Replacement Axle With A 95 Inch Hub Face
Published 04/28/2022
Products Featured in This Question
Question:
my hub to hub is 95 but spring center to center is 78?
asked by: Steve S
0
Expert Reply:
The correct replacement for you 95 inch hub face measurement is The Trailer Axle Beam with Easy Grease Spindles - 95 inch Long - 7,000 pounds # e88GR. The spring centers are 80 inches apart so you will have to remove them and weld new spring seats to the locations that you measured using The Spring Seat # TRSS300. The spring center is measured from the center of each seat.
I attached a review video link below.
expert reply by:
Noah E
0
Product Page this Question was Asked From
Trailer Axle Beam with Easy Grease Spindles - 95" Long - 7,000 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 7000 lbs
- Spindles Only
- 80 Inch Spring Center
- 95 Inch Hub Face
- No Drop or Lift
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Difference Between Blue Ox BX7380 Alpha 2 and Original Alpha Tow Bar
- Article: Trailer Wiring Diagrams
- Q&A: Bearing Kit Recommendation for Lippert 5,100 lb Trailer Axle
- Q&A: Replacement Master Cylinder for a Titan Aero 6000 Drum Brake Actuator
- Q&A: Can the Titan Aero 6000 Surge Brake Actuator Be Repaired Or Should It Just Be Replaced
- Q&A: Meaning of 8 on 6-1/2 Inch Bolt Pattern for Dexter Hub # 8-285-11
- Q&A: Can I Swap My Coleman Mach 10 for the Furrion Chill Cube RV 18,000 Btu?
- Q&A: Changing from 10 x 1-3/4
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Maintenance Schedule
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer