Is There Advantage to Grounding Trailer Wiring to Trailer Frame
Published 04/19/2022
Question:
Why not run a white ground wire to each light instead of using the trailer for a ground?
asked by: Fisher
0
Expert Reply:
You can run a ground wire for each light but that ends up requiring a lot of wire and running the ground straight to the trailer frame is just as effective, much easier, and also is less susceptible to damage since loose wire tends to catch on things and cause problems.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What Size Socket Does the Dexter Dual Trailer Wheel Lug Nut with Swivel-Flange Use
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2014-2015 GMC Terrain
- Q&A: How To Wire LED Trailer License Plate Light For Cargo Carrier To A 4 Way Flat
- Q&A: Installing Leaf Springs on Single Axle Trailer
- Q&A: Screws Needed To Attach 5/8" Treated Plywood To Aluminum Snowmobile Trailer Frame
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers