What Portion of Wheelmasters Hose Inflation Kit # WM8005 are Stainless Steel
Published 04/13/2022
Question:
Are the mounting brackets and rivets stainless steel?
asked by: Steve H
0
Expert Reply:
The mounting brackets and rivets of the Wheelmaster # WM8005 are not stainless steel. Only the braiding of the air line is stainless steel.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Wheel Masters 2-Hose Inflation Kit - 22-1/2" Dually - Hub Mount
- Tire Inflator
- Inflation Kit
- 22 Inch Dual Tires
- Dually Vehicles
- Wheel Masters
more information >
Continue Researching
- Q&A: Correct Floor Flange Seal for Dometic 300 Series Toilet
- Q&A: Replacement Gas Strut For a Stabilus 654150 0550N 275/12 A 15
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: Need Wiring Instructions for Wall Remote Switch # VC0533-03-A on Ventadome Roof Vent with 12V Fan
- Q&A: Seat Stiffener to Secure a Supplemental Braking System in Vehicles with Soft Seats
- Q&A: Tip for Fitting Blue Ox Patriot Braking System in 2014 Jeep Wrangler
- Q&A: Starter Solenoid for Generac Generator
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: RV Propane 101: How Does My RV's Propane System Work?