Where are Torklift Hitch Extenders Measured From
Published 04/13/2022
Products Featured in This Question
Question:
Hi there. Been looking on the QandA, just doesn’t seem to be a solid answer… 2018 F350 DRW with Eagle cap 955. From the Face of my 3” factory receiver to the rear of my truck camper bumper is 41” Where EXACTLY do the torque hitch extensions measurements come from ? Pin to pin or pin to the face? Or truck receiver face to the hitch extension face?? Ideally the shorter the better for sway and weight, so the 42” or the 48” is what I’m trying to accurately figure out Thanks.
asked by: Ron S
0
Product Page this Question was Asked From
TorkLift Cannon Hitch Extension - 3" Ford Super Duty Factory Hitch - 48" Long
- Hitch Adapters
- Hitch Extender
- Trailers
- 48 Inch Extension
- Fits 3 Inch Hitch
- 6000 lbs
- TorkLift
more information >
Continue Researching
- Article: How to Mount a Truck Bed Camper
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can The TorkLift Cannon Hitch Extension Be Used To Flat Tow With A Truck Bed Camper
- Q&A: What Camper Tie-Down do I Need for My 2021 Ford F-350 DRW 8ft Bed? What are Talon?
- Q&A: Best Air Bag Kit For 2022 Ford F-350 Dually With B&W Companion Hitch
- Q&A: Can I Extend My Hitch Without Using TorkLift Hitch and SuperTruss Extension
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Q&A: Are The Lengths of the TorkLift Cannon Extensions The Overall Length or the Extension Length
- Q&A: Recommendation for Towing a Trailer with a Hitch Extension
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Stability Control for Heavy Duty Vehicles
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: How to Change a Trailer Tire