Is There Yakima Landing Pad that Fits Thule Roof Rack Tracks

Question

Question:

I have Yakima bars and towers. I purchased a new canopy for my truck and am looking at installing some rack rails. I am looking at alternatives. Will Yakima landing pads work with this track? If so, which landing pads?

asked by: G L

1

Helpful Expert Reply:

Yes, the Yakima Landing Pad 1 part # Y00221 does fit the Thule tracks like part # THTP54 that you referenced.

expert reply by: Jameson C

1

Answer 1

Yes, the tracks themselves recreate the factory C-shaped rack tracks. Thule Tracks #THTP42 and Yakima Tracks #Y01126 have the same C-channel design, but differ in length and how they mount to the vehicle. To use your SkyLine Towers #Y53TR with these…

view full answer...

Answer 2

Good question, Ron! The Yakima Landing Pad 1 #Y00221 you have will indeed work with the Yakima 72" HD Tracks #Y84MR. With that said, the weight capacity will be lower than with the Landing Pad 26 #Y75ZR and HD Bar combo. It will only have a 165…

view full answer...

Answer 3

You are correct, with that diesel engine you are limited. The best option is going to be the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers item #AL88288. These have a 5,000 lbs load leveling capacity and come with…

view full answer...

Answer 4

The Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88288 is the best kit we have for what you are looking for. It allows you to change the air pressure inside the springs for your 2023 GMC Sierra 1500 depending…

view full answer...

Answer 5

Hello Martin, thanks for reaching out. An air bag kit will be the best suspension enhancement option for your 2024 GMC 1500 Denali. Air bags are great because they allow you to fine-tune your suspension based on what kind of load you are hauling. You…

view full answer...

Answer 6

I checked with Furrion and the 7 inch and 5 inch monitor version of the Furrion observation system #FOS05TASF use part #FR79SR. The smaller 4.3 inch size use the part #LC776462. The ball of the #FR79SR is 0.85" or 21.59mm and the ball of the…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Bernie! From everything I could find about your 2025 Chevy Silverado 1500 Custom, the mirrors are the same as the higher trim models (see attached image). The Longview Custom Towing Mirrors - Slip On - Driver and Passenger Side #LO54FR will fit…

view full answer...

Is There Yakima Landing Pad that Fits Thule Roof Rack Tracks

Products Featured in This Question

Continue Researching