Inner And Outer Diameter Measurements Of The JR Products Mushroom Vent

Question

Question:

Need to know the inner diameter where it ventilates and the outer diameter of the over all flange.

asked by: John

0

Expert Reply:

For the Mushroom Vent # 37202-29115, the inner diameter of the ventilated area is 4-1/8" wide, and has an overall flange measurement of 5-13/16".

expert reply by: Bryce D

0

Vented Flange Dimensions
(click to enlarge)

Answer 1

If there is a tiny bit of play in suspension components that are designed to move you would be fine. 1/16 of an inch isn't very much, and as long as you torqued everything down to spec you would be good to go. Ideally we just don't want it…

view full answer...

Answer 2

Hey Dustin, thanks for reaching out! You'll need the MORryde ALLTREK 4000 #MR89DR if you have a 33" wheelbase, or the kit #MR29DR if you have a 35" wheelbase. The wheelbase is measured from the center of the front wheel to the center of…

view full answer...

Answer 3

There should be enough free play in the shackles to allow them to move. There is no specific torque rating for shackle bolts. The first thing you should make sure of is that the bolts you use are long enough so that when installed you will have at…

view full answer...

Answer 4

Hey Aidan, a small amount of play is fine in your leaf springs. If the springs are sagging significantly then that could indicate that your springs are worn or there may be other suspension problems. If you notice any of that, then you are going to…

view full answer...

Answer 5

The common recommendation with oil bath hubs is to not mess with them at all as long as they aren't leaking or the oil isn't milky looking. Some say to change every two years but most will say that as long as everything looks good just leave…

view full answer...

Answer 6

There is no specific torque rating for shackle bolts. You'll want to ensure that the bolts you use are long enough so that when installed you will have at least 2 threads protruding from the nut. Make sure that the bolt you're using has a…

view full answer...

Answer 7

Hi Steve! For your application you need the Replacement RV Air Conditioner Cover for Dometic Duo-Therm #DMC69FR. This was initially designed around a different Duo-Therm model, but we've found that this will still work with your 3107541.009.

view full answer...