What are the Dimensions of the Replacement Rubber Socket # DH38S
Updated 08/15/2013 | Published 08/14/2013
Question:
What is the outside diameter of the rubber? Attempting to replace in an aluminum door stop plunger in 1978 Avion travel trailer. Plunger is welded onto trailer.
asked by: Jeff
0
Expert Reply:
I went out to the warehouse and measured the Replacement Rubber Socket # DH38S. The outer diameter is approximately 1-5/8 inches (1.62). The inner diameter is approximately 13/16 inches (0.81). And the height is approximately 1-3/8 inches (1.36).
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement Rubber Socket for DH38R and DH39R
- Accessories and Parts
- RV Door Parts
- Trailer Door Parts
- Door Holder
- Socket
- Redline
more information >
Continue Researching
- Q&A: Replacement Plunger Door Holder Socket for a Polar 68 Socket
- Q&A: Longest Available Door Replacement Plunger
- Q&A: Correct Atwood LPCO 36636 Wires to Connect to RV Propane Gas and Carbon Monoxide Detector
- Q&A: Replacing Mobile Home Trailer Hub With a Hub that is Compatible with Standard Rims and Tires
- Q&A: Rear Door/Ramp Latch Placement for Horse Trailer
- Q&A: Can 2-Step Lippert Steps Replace a Single Step on a 2017 Winnie 170S
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How (and Where) to Connect an RV Propane Grill