What Causes Trailer Suspension Equalizers to not Sit Level
Updated 03/01/2022 | Published 02/28/2022 >
Question:
Hanger spacing for 2006 vortex 3950 5th wheel. Correct axle spacing please. Currently 29.5 front to 2nd hanger and 3rd to rear hanger space, and 33 center space. Axles tilt now when driving more tha photo.
asked by: Wayne G
Expert Reply:
The amount of tilt I see in the pictures you submitted of your equalizer isn't too bad. That could easily be from the trailer not sitting perfectly level. If the trailer is level and it's still tilting this can be solved in one of three ways. You either go with shorter leaf springs, a shorter in width equalizer, or you move the rear and front hangers out about half inch.
Product Page this Question was Asked From
Dexter Heavy-Duty Suspension Kit for Triple-Axle Trailers - 1-3/4" Wide Double-Eye Springs
- Trailer Suspension Parts
- Suspension Kits
- Boat Trailer
- Snowmobile Trailer
- Double Eye Springs
- Dexter
more information >
Continue Researching
- Search Results: trailer breakaway kit
- Search Results: 3 leaf trailer leaf springs
- Search Results: brake line kit
- Search Results: 7 way to 7 way extension
- Shop: Dexter Heavy-Duty Suspension Kit for Triple-Axle Trailers - 1-3/4" Wide Double-Eye Springs
- Search Results: triple axle hanger kit
- Search Results: rail kits
- Search Results: rvstb61
- Shop: Dexter Trailer Hub Drum Assembly - 9K to 10K - 8 on 6.5 - Oil Bath - Non-ABS Drum - After July 2009
- Shop: 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4" Long
- Shop: Dexter DX7.5L A-60 Brake Actuator w Electric Lockout - Bolt On - Disc - 2" Ball - Zinc - 7.5K
- Shop: Timbren Axle-Less Trailer Suspension - Standard Duty - No Drop - 1,200 lbs
- Shop: Timbren Axle-Less Trailer Suspension - Standard Duty - No Drop - 4 Bolt Flange - 2,000 lbs
- Q&A: Is 34" Axle Spacing Okay for the Dexter Axle Suspension Kit # K71-360-00
- Video: Feature Breakdown: Triple-Axle Trailer Hanger Kit for Double-Eye Springs
- Shop: 4-Leaf Slipper Spring w/ Open Eye End for 4,700-lb Trailer Axles - 26-1/4" Long
- Q&A: Recommendation for Adding Third Axle To Trailer Suspension
- Q&A: How To Determine Correct Leaf Spring Hanger Spacing for the Dexter Heavy Duty Suspension Kit
- Q&A: Oil Bath Hub Oil Cap for Pre 1996 Quality Axles 3-1/2 x 14 Thread Pitch
- Video: Trailer Wiring Harness Installation - 2009 Ford Van
- Video: How to Install: Curt Trailer Hitch Receiver on your 2008 Ford Van
- Q&A: Recommended Parts To Convert Trailer From Hydraulic Surge Brakes To Electric Over Hydraulic Brakes
- Video: Installing the Blue Ox Trailer Hitch Receiver on a 2023 Jeep Grand Cherokee L
- Q&A: Determining If Dexter Heavy Duty Suspension K71-360-00 WIll Fit 2008 Heartland Cyclone Toy Hauler
- Q&A: Dexter Heavy Duty Greasable Shackle Kit Needed
- Video: Installing the Curt T-Connector Vehicle Wiring Harness on a 2024 Toyota Sienna
- Video: Comprehensive Review: Advent Air Low Profile RV Air Conditioner
- Video: Installing the MORryde Rubber Equalizers on a 2018 Grand Design Momentum 5W Toy Hauler
- Article: Where to Position the Trailer Axle?
- Article: Slipper Spring Trailer Suspension System Review


