How To Wire In 4-Wire Furrion Side Marker Cameras With Only Two Running Light Wires

Updated 02/15/2022 | Published 02/14/2022

Question:

Hello, I have the Furrion 3 camera set. I want to install the side cameras, but I need some clarity. I have 2 wires that power my existing light. I see the labeling on the furrion, but of the 4 wires on the Furrion, brown, black, red, and yellow. Do all but the ground get wired to power? Thanks for your help.

asked by: Jeff A

Expert Reply:

On the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras # FCE48TASL-05 the Red (V+ Camera) goes to the positive wire of the running light circuit, the Black (GND) to the ground, the Yellow (Trigger) to the left/right turn signal (only available for LED versions), and the Brown (V+ Lamp) to the positive wire of the running light. If you had a turn signal circuit you would need to wire the Yellow wire to that, but since you don't you can just cap the wire with some electrical tape.

In summary, you'll twist the Brown and Red together and run them to the running lights circuit so that anytime you turn on the headlights the cameras will receive power, the Black wire will run to your ground, and the yellow wire will be capped off.

expert reply by: Kevin C