Why Doesn't E-Track Wood Beam Socket # 59149 Have Weight Capacity
Published 01/24/2022
Question:
If I install the holder on the top rail angle iron of a utility trailer, what is the weight capacity on the holders as a cross beam for 5’ length
asked by: Dennis
0
Expert Reply:
The E-Track Wood Beam Socket # 59149 that you referenced doesn't have a capacity listed for it because the wood installed in it would break long before it would. Using it with angle iron instead of wood like it was intended for would make it really hard to give a stated capacity.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
E Track Wood Beam Socket for Standard 2" Lumber - Qty 1
- E Track
- E Track Cargo Organizers
- Board Holder
- Erickson
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Can I Use the etrailer High-Low Fixed Adapter for Tow Bars e85ZV on a Boat Trailer?
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Lug Nut Upgrade for Lionshead LR103 Capped 1/2" Lug Nut
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Q&A: Air Helper Springs For A 2020 Mercedes-Benz Sprinter 2500
- Q&A: Brake Controller Install On 2019 Mercedes-Benz Sprinter 2500 Without Green Plug Under the Seat
- Q&A: Location of Brake Controller Fuse on a 2001 Chevy Silverado
- Q&A: Is Passive Inlet Vent Needed With Ventline Powered Vent in Camper Shell?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft