Will Redline 2-Way Pop-Up Trailer Roof Vent with Garnish Fit the Curved Roof of a Teardrop Trailer
Published 07/10/2013
Products Featured in This Question
Question:
Will this vent have enough water proof gasket thickness to seal the curved roof on a tear trailer? Caulk? Any alternatives to flat vents has to be less than 8 inches wide on one side.
asked by: Bernard B
0
Expert Reply:
The gasket that comes with the 2-way vent # 9106-2756 is flexible enough that it should work well on a slightly curved surface. However, I would still use some silicone sealant like # 0160297 for additional protection. We also have this vent in an aluminum finish, # RV-626-062.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Redline 2-Way Pop-Up Roof Vent with Garnish for Enclosed Trailers - Steel
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- No Fan
- Metal
- Black
- Redline
more information >
Continue Researching
- Q&A: What Is The Span Or Usable Length Of RV Designer Hitch Pin - 1/2" # RD83GR
- Q&A: What is Usable Span of Coupler Pin - 1/4" Diameter x 3" Long # 37201281
- Q&A: Side Wall Vent Recommendation for an Enclosed Trailer for Maximum Air Flow
- Q&A: What RV Roof Vent Lid Material Would Hold Up Best Over Time
- Q&A: Can The Solera Awning Cradle Support LC289373 Be Used On Awning With Metal Weather Shield?
- Q&A: Roof Vent for Dog Box Truck Topper
- Q&A: Could Redline 2-Way Pop-Up Roof Vent # 9106-2756 Install in Ford Transit Connect Van
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Converting Your RV Water Heater to Tankless
- Article: Ram Trailer Tow Prep Package
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Determining Trailer Tongue Weight
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft