Would WeatherTech Bumper Step part # WT81BS1 Interfere with Backup Sensors
Published 11/16/2021
Question:
I have a 2011 z71 crew cab Silverado will the xl bump step up get in the way of back up sensors
asked by: David E
0
Expert Reply:
I wouldn't think so, but to be sure you can compare the measurements of the Weathertech part # WT81BS1 to the backup sensor locations. This is overall 11-1/2 inches wide and 2-1/2 inches tall. This should be small enough and also low enough not to interfere in anyway.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
WeatherTech BumpStep Hitch-Mounted Bumper Protector and Step for 2" Hitches - 300 lbs
- Hitch Step
- Fixed Step
- Smooth Step
- 3 Inch Deep
- 300 lbs
- 2 Inch Hitch
- 11 Inch Wide
- Plastic
- WeatherTech
more information >
Featured Help Information
Instructions
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: What Camper Tie-Down do I Need for My 2021 Ford F-350 DRW 8ft Bed? What are Talon?
- Article: How to Mount a Truck Bed Camper
- Q&A: 2021 Honda Pilot Trailer Hitch Receiver and Hands Free Lift Gate Compatibility
- Q&A: Will Hands-Free Liftgate Feature on 2022 Honda Pilot Still Work After Trailer Hitch is Installed
- Q&A: Can Exterior RV Ladder Be Attached To Coleman Lantern Travel Trailer With Corrugated Type Siding
- Q&A: Difference Between Swagman XTC-2 and XC 2 Platform Bike Racks
- Q&A: Installation of Westin # 27-6135-1725 Sure Grip Running Boards on 2013 Toyota Tundra Double Cab
- Q&A: Dimensions of Yakima Anchor Plate A Part # Y8810074 and 60-Inch Track for Roof Racks
- Article: Trailer Wiring Diagrams
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Install E-Track in 3 Easy Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?