Tow Hook Re-Installation with Curt Front Mounted Receiver # 31021 on 1999 Chevy Blazer 4-Dr 4x4
Published 06/13/2013
Question:
Two questions. Will this fit a 99 Trailblazer 4D, 4WD? The directions you have posted state that the factory tow hooks must be removed for installation, can they be reinstalled along with the hitch using the provided bolts?
asked by: James P
0
Expert Reply:
According to my contact in the engineering department at Curt Manufacturing, the tow hooks can indeed be reinstalled with the front mounted receiver, even though the installation instructions do not specifically address this.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 350 lbs Vert Load
- 3500 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Wire an Electric Winch on the Front or Rear of a Vehicle or on a Trailer
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Will The Curt Front Hitch 31313 Fit A 2007 Toyota Tacoma 4 Wheel Drive?
- Q&A: Draw-Tite vs. Curt Front Mount Trailer Hitch Receiver for 2020 Ford f-150
- Q&A: Do all Front Hitches for 2019 Toyota Tacoma have Tow Hooks in Front
- Q&A: Removing Skid Shield to Install Front Mounted Receiver on 2014 Toyota Tacoma
- Q&A: Front Trailer Hitch Receiver That Will Allow For the Skid Plate To Mount On a 2008 Toyota Tacoma
- Q&A: Does Curt Front Hitch for 2004 Nissan Titan Extend Out Past Front Bumper
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Install a Trailer Hitch
- Article: Rooftop Cargo Carriers
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: What Kind of Hitch Do I Need for a Travel Trailer
- Article: Best Vehicles to Flat Tow Behind an RV