Opening Dimensions for the Trailer Valet Replacement Crank Assembly
Published 10/06/2021 >
Question:
Will this work for my 1998 Dutchmen pop-up camper?
asked by: Daphne P
0
Expert Reply:
We haven't tested it, but I can tell you the size of the opening and the distance to that pin hole for the Replacement Crank Assembly # TV0006.
The opening is 1.5 cm square and then from the opening to the center of the pin hole is slightly over 2 cm. I confirmed this with my contact at Trailer Valet.
While this is designed to fit a Trailer Valet product, if it matches the specs that you're needing you should be able to use it just fine to operate your pop-up camper.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Crank Assembly for Trailer Valet Swivel Jack and Trailer Mover
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Trailer Valet
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Towing Mirrors for a 2025 Jeep Grand Cherokee
- Q&A: Towing Mirrors for a 2022 Jeep Grand Cherokee L
- Q&A: Recommended Replacement For An Elixir ELX-20 RV Converter
- Q&A: Recommended Ladder Rack Compatible With A BAKFlip MX4 Cover That Sits Lower Than Cab Height
- Q&A: Can Advent Air RV AC Unit Control Furnace
- Q&A: Is the Wall Mounted Thermostat with Advent Air RV Air Conditioner System a Real Thermostat?
- Q&A: What To Do If Old AC Unit Is Hardwired Into Camper And Does Not Have A plug?
- Article: How to Install an Electric Trailer Jack
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How To Measure And Replace Everything In Your Hub Assembly


