How Does Heat Strip Get Installed on Furrion Chill RV AC Unit

Published 09/27/2021

Products Featured in This Question

Furrion Heat Strip Add-On for Furrion Air Conditioner - Manual

(56)

$88.95

Question:

I bought this so I could add the heat strip and have the 3speed fan. But dont see where to connect heat strip wiring. I converting from a Colman Mach unit. Adding a heat strip to the furrion chill unit

asked by: Jim M

Expert Reply:

Furrion does have a heat strip available for their Chill RV AC Units with the part # FR35SR. Here is the instructions for installing this on a Chill unit:

You will need to remove the 10 screws holding the top cover on, remove the EPP top cover of the evaporator, align the 4 bolts of the heat strip with the evaporator and use provided hardware to bolt heat strip to evaporator, route the harness down through the air intake vent, remove the 3 screws from the electrical control box and remove the covers and controls, plug black wire from harness into H pin on switch, install white neutral wire in junction box with other neutral wires, install 3 pin connector into reserved opening on electrical control box, reinstall 3 screws for electrical box, plug in 3 pin connector from heat strip to new installed 3 pin connector in electrical box.

expert reply by: Jameson C