Is the Curt Ball Mount Compatible with the Curt A-90 Ball?
Updated 09/23/2021 | Published 09/22/2021
Products Featured in This Question
Question:
Hi, can you please tell me If the curt A-90 hitch ball fits the curt C45310 ball mount? I am just not certain if the shank on the ball is too long to tighten the nut completely to the mount. Thank you
asked by: Ezra Z
0
Expert Reply:
Yes, the Curt item # A-90 hitch ball fits the Curt Ball Mount for 2" Hitches item # C45310. I recommend the Curt Towing Starter Kit for 2" Hitches - 2" Ball - 3/4" Rise, 2" Drop - 7.5K item # C45534. This will give you both the ball mount and the ball as well as a lock for your hitch mount.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Curt Ball Mount for 2" Hitches - 1" Rise, 2" Drop - 9-3/8" Long - 10,000 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Parts Needed To Switch Trailer From Standard Ball Coupler To Pintle Hitch System
- Q&A: Lock N Roll 50-Degree A-Frame Coupler Measurements
- Article: Which Hitches are Made in the USA
- Q&A: Where Does Brake Controller Install Harness Plug In on 2015 Chevy Suburban
- Q&A: Parts Needed to Connect a Vehicle Battery to an Anderson Connector on a Trailer
- Q&A: Can Weight Distribution Hitch Be Used With Cruisemaster DO35
- Q&A: Replacement Bearings 2788 and 1779
- Article: Trailer Wiring Diagrams
- Q&A: Is There a 2 Inch Ball Mount with 1 Inch Drop
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Best Landing Gear
- Article: Trailer Jacks