Do Old Spring Seats have to be Removed to Move Springs On Top of Trailer Axle

Updated 05/21/2013 | Published 05/18/2013

Products Featured in This Question

Spring Seat for Typical 3,500-lb, Round Trailer Axles with 2-3/8" Diameter

(641)

$15.16

Dexter Trailer Springs Over-Under Conversion Kit

(788)

$84.28

Question:

I just ordered a set of axel pads for a 2 3/8 round axel. Am putting the axel on the bottom of the springs, Do I have to cut the old pads off?

asked by: Tom W

Expert Reply:

You do not have to remove the old spring seats unless they cause a clearance issue. But keep in mind that the new spring seats will have to be welded to the axle. Welding should be performed by a qualified professional with experience working on trailers.

If you were to use an over-under conversion kit, # K71-384-00, you would not have to do any welding.

expert reply by: Michael H