Can Multiple Coil SumoSprings Be Used On a 2021 Ford Expedition
Updated 09/09/2021 | Published 09/08/2021
Question:
Can you double up the coil springs to make even more stout in the rear when hauling an RV? My 2021 Ford Expedition has too much sag in the rear end when hauling my 20 foot toy hauler. I am wondering if only the one set will keep the rear suspension from sagging too much.
asked by: Mike B
Expert Reply:
The Coil SumoSprings Custom Helper Springs for Coil Spring Suspension part # CSS-1168F which are a fit for a 2021 Ford Expedition will help the coil springs from compressing which will in turn prevent sag/squat. There will only be one spacer per side needed. It would not be advised to install more than one per side as they would likely not fit and the ride would be very harsh if done so.
Product Page this Question was Asked From
Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Front Axle
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Front Axle Suspension Enhancement
- SuperSprings Intl
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: airlift 1000
- Search Results: hitch bracket
- Search Results: riser
- Search Results: hitch carrier
- Search Results: no drill bracket
- Search Results: no drill mount
- Search Results: airlift
- Video: Review of CURT Mounting Bracket 4 And 7 Way Connector Plug - C32NR
- Video: Review of the etrailer Hitch Anti Rattle on a 2025 Toyota Sienna
- Shop: Trailer Hitch
- Shop: Suspension Enhancement
- Q&A: Recommended Hitch and Wiring Harness for a 2006 Toyota Sienna
- Shop: Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs - Rear Axle
- Shop: BOLT brand vehicle and hitch locks
- Shop: Lift Assist
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Wiring
- Shop: Catalytic Converters
- Video: Detailed Breakdown of the Curt Mounting Bracket for 4-Pole Flat Trailer Connector
- Video: Setting up the etrailer Trailer Hitch Receiver on your 2006 Toyota Sienna
- Video: Curt Mounting Bracket for 4-Pole Flat Trailer Connector Review
- Video: An In-Depth Look at the Draw-Tite QSP Trailer Hitch Silencer and Cover for 2" Hitch Receivers
- Video: Review of Hopkins Custom Fit Vehicle Wiring - Plug In Wiring Harness 4 Pole Flat - HM11143485
- Shop: Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Front Axle
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Q&A: Recommended Weight Distribution System for a Minivan Pulling a Pop Up Camper