What Lube Is Needed To Remove or Install Grommet On Trailer Tail Light
Updated 09/07/2021 | Published 09/06/2021
Question:
What lubricant do you use on grommets
asked by: Tony
1
Helpful Expert Reply:
In regards to removing or installing a light with large rubber grommet like the Peterson Trailer Tail Light part # 435800, you can use anything from a soapy water mix or a can of WD-40. It's simply helping the light install or remove with less force as to not damage the rubber.
expert reply by:
Conner L
1
Product Page this Question was Asked From
Peterson Trailer Tail Light w/ Grommet and Plug - Stop, Turn, Tail - Incandescent - Round - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 4-1/4 Inch Diameter
- Red
- Peterson
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement LED Trailer Light for Petersen 410-25 Light
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Converter for PD9245C that is Lithium Battery Compatible
- Q&A: What Hole Size is Needed for Flush Mount of Peterson # 435800 Sealed Tail Light
- Q&A: Recommended Brake Controller w/ EOH Functions for a 1997 Ford F-350 w/the Factory 7-Way Connector
- Q&A: Replacement P02860 Grease Seal For Lippert Axle On 2019 Keystone Cougar
- Q&A: Replacement for 5973820 Motor for Kwikee Series 28 RV Step
- Q&A: Replacing American CS6000XL in Camper
- Article: What Do I Need To Tow A Trailer?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle