Angled Up Bracket Solution for Rhino Rack Sunseeker Awning on Square Crossbars
Published 08/23/2021
Question:
Im looking for an angled up mount bracket to place my rhino rack batwing compact on my dyi offroad trailer with 2inch square cross bar rack built on it. Do you have anything that will work with this? The batwing compact is what is laying on it.
asked by: John M
0
Expert Reply:
We don't have anything custom fit for the crossbars of your offroad trailer but you most likely could use the Angled Up Mounting Brackets for Rhino-Rack Sunseeker Awning # RR32123 that you referenced if you were okay doing some fabrication.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Angled Up Mounting Brackets for Rhino-Rack Sunseeker Awning - RSP, RS 2500, and SG Roof Racks
- Accessories and Parts
- Car Awning
- Mounting Hardware
- Brackets
- Sunseeker
- Rhino Rack
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will the Yakima SlimShady Mount Bracket Fit an ARB Awning and Yakima Round Bars?
- Q&A: Dimensions of Rhino Rack RR32133 Sunseeker Roof Rack Mounted Vehicle Awning
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Side Wall For Rhino Rack Dome 1300 Awning
- Q&A: Can Rhino Rack Sunskeeker Awning Fit Thule Wingbar Evo without Adapter
- Q&A: Distance Between The Mounting Tabs On A The Roadmaster Direct-Connect Base Plate Kit # 1437-3
- Article: How to Measure for Motorhome Steps
- Article: How to Install an RV Awning From Scratch