Replacement Drive Head For Solera Slide Topper Awning
Published 08/13/2021
Question:
Torque arm broken on my Solera slide topper. Looking at the slide the right arm is broken I believe this should be the Drive end. The slide is 69-3/4 inch from outside flange to outside flange. The actual roll is 77 inches end to end. What do I need to order to repair this ?
asked by: Randy
Helpful Expert Reply:
You are correct that the right side is the drive head side, and we do have a replacement for your Solera slide topper awning so you can make a repair; what you need is the following part:
- Replacement Drive Head and Roll Tube for Solera RV Slide-Out Awning # LC34FR
Product Page this Question was Asked From
Replacement Right-Side Head and Roll Bar for Solera RV Slide-Out Awnings - Black
- Accessories and Parts
- RV Awnings
- Head Parts
- Rollbars
- Head Assembly - Manual
- Solera Replacement
- Drive Head
- Lippert
more information >
Continue Researching
- Q&A: Replacement Driver Head and Idler Head for Lippert Solera Slide Out Awning
- Q&A: Instructions For Replacing Drive Head and Idler Head On a Solera Slide Out Topper Awning
- Q&A: Replacement End Caps For Lippert Solera 1000 Series Slide Topper Awning
- Q&A: Replacement Drive Head And Roll Tube Assembly For Lippert Solera Awning
- Q&A: Replacement Right-Side Head and Roll Bar For a Solera Slide-Out Awning
- Q&A: RV Furnace Recommendation to Replace Atwood 2334DCLP
- Q&A: Replacement Hex Extension Rod For Solera Slide Toppers
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Performance Chips and Modules
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams