Troubleshooting RVS Camera System Where Side Camera Sticks On After Blinker
Updated 04/02/2024 | Published 08/12/2021
Question:
Hello - I have a 2018 Coachmen Orion that has an RVS-770619N factory installed with a backup camera and two side cameras. After taking the RV out of storage after almost a year, I noticed something peculiar happening with the camera. I usually leave the rear view camera on while driving, and then when I use the turn signals, it switches to that view for about 5 seconds or so and then goes back to the rear view. But yesterday it stuckinch on the side view and the monitor buttons would not respond at all to change the view, power it off, nothing. After I got home, I let the RV sit for a while and when I came back out and tried it, everything worked as usual. I left the RV running for about 15-20 minutes, went inside and tried it again and everything was stuck. Any idea on what my issue may be? I am leaving for a trip this weekend, and I am pretty concerned driving without it working properly Thanks!
asked by: Jim S
Expert Reply:
When the view is stuck what is the lighting functions of the setup doing? Are any of the turn signals or brake lights sticking on at the same time or are they functioning fine?
If the light functions are staying on you have a lighting short that is confusing the camera system. If the lights are functioning fine the issue would be the multiplexer which you could replace with the # RVS-501N.
Product Page this Question was Asked From
Rear View Safety Multiplexer Box - 3 Channel
- Accessories and Parts
- Backup Camera
- Multiplexer Box
- Rear View Safety
more information >
Featured Help Information
Instructions
Continue Researching
- Video: A Closer Look at the Rear View Safety Multiplexer Box
- Shop: Rear View Safety Multiplexer Box - 3 Channel
- Search Results: slide motor
- Search Results: 523900
- Shop: Rear View Safety Switcher Box
- Q&A: Can Second Camera be Added to the 7 Rear View Safety Backup Monitor
- Search Results: air mattress
- Q&A: Troubleshooting A Non-Working Rear View Safety Camera Mirror Monitor
- Shop: Replacement Gear Motor Assembly for Slide-Out Motor Assembly
- Shop: Replacement Gear Motor Assembly for Lippert Power Gear Slide Outs - Motor Number 524864
- Shop: Lippert RV Slide-Out Motor by Klauber
- Shop: Replacement Slide Gear Motor Assembly for Power Gear Slides
- Shop: Replacement Gear Motor Assembly for Lippert Slide-Out Motor Assembly
- Q&A: Difference Between RVS Switchers RVS-501N and RVS-501N-3
- Q&A: Attaching A Blue Ox Avail Tow Bar To A Roadmaster Base Plate
- Shop: Vehicle Seat Covers
- Video: Review of Pop Step RV Step Covers - PS24UR
- Q&A: Rear View Safety Switcher Box RVS-501N-3 Wont Trigger
- Search Results: wiper arm
- Search Results: windshield wipers accessories and parts
- Q&A: Recommended Driver And Passenger Seat Cover For Captain Chair on 2012 Thor Ace 29.2
- Q&A: Captain Seat Covers for 2017 Thor Hurricane 29M
- Video: Let’s Check Out the Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision
- Video: Roadmaster 2nd Motorhome Alarm Kit Review
- Article: Trailer Wiring Diagrams
- Video: Review of Rear View Safety Backup Camera - RV Camera System - RVS99FR
- Shop: Truck Bed Camera
- Video: Replacement Monitor Wire Patch Cord for Roadmaster InvisiBrake System Review
- Video: Hands-On with the Replacement Monitor Wire for Roadmaster LED Braking Indicator
- Search Results: backup camera monitor
Ray S.
3/31/2024
Would this fix apply to an earlier model 2007 Winnebago Sightseer? My blinkers work on the outside but on the inside the right blinker light is stuck on and the monitor is stuck on the right camera. The alarm sounds every minute or so since it thinks the right blinker stuck is on. This problem is intermittent which I would think would rule out components on the fuse box? Should I replace the multiplexer and the wiring harness? I have not taken it apart yet. Thank you!