How To Find Correct Replacement Dexter Drive-In Wheel Stud

Updated 08/10/2021 | Published 08/09/2021

Question:

Recently had studs break on boat trailer. They look to be dexter as they have a Dinch on the end. they are total length of @2 1/4, drive in section is @9/16, wheel hub section is@1/2inch and remainder is the threaded section @1inch long. Not sure is #7232 is correct.

asked by: Rob B

Expert Reply:

In order to choose the correct replacement wheel stud you'll need to take some very specific measurements of the spline and shaft. These measurements are listed on each product page for the replacement stud such as the Replacement Drive-In Trailer Hub Wheel Stud part # 7-232.

expert reply by: Conner L