Are the mounting screws stainless steel on the LED Trailer Light Kit, part # TLL9RK?
Updated 08/27/2009 | Published 08/24/2009
Question:
are the mounting screws on the back of the lights stainless ?
asked by: Ken F
0
Expert Reply:
Yes, the mounting hardware included with the Waterproof, Under 80 inch LED Trailer Light Kit with 25 foot Wiring Harness, part # TLL9RK, is stainless steel and corrosion-resistant.
expert reply by:
DeAnne T
0
Product Page this Question was Asked From
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Reflector
- Stop
- Tail
- Turn
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Does etrailer Trailer Hitch Receiver for 2018 Dodge Journey Include Fishwire
- Q&A: Will A Spare Tire With A Higher Load Rating Be Ok On A 2022 Aluma 7814ST?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Does the Submersible, Under 80" LED Trailer Light Kit part # TLL9RK Wire to Trailer
- Q&A: How Do I Measure To Find The Correct Bolt Pattern For My Wheel?
- Q&A: How to Measure for a Replacement Axle, Hubs, and Leaf Springs for a Boat Trailer
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Parts Needed To Switch Trailer From Standard Ball Coupler To Pintle Hitch System
- Q&A: Availability Of 2-5/16" A-Frame Coupler With Holes That Match Bulldog BD43805W0317