What Size Mounting Hardware is Required to Install the Trailer D-Ring Tie Down, # RR06

Question

Question:

What size are the mounting bolts?

asked by: Ron

0

Expert Reply:

The Trailer D-Ring Tie Down, # RR06, has mounting holes that are 1/4 inches in diameter. We recommend using backing plate # BP06 when installing this tie down to provide support for the tire down.

expert reply by: Michael H

0

Answer 1

I went out into our warehouse and measured the Backing Plate #BP06 and found that the outside dimensions are 6-7/16 inches by 6-1/2 inches. The circle in the middle has a 4-5/8 inch diameter and the overall thickness of the metal plate is .11 inches…

view full answer...

Answer 2

Hey Steven, the hole you'd need to cut to install the etrailer D-ring part #RRING-Q6000 will need to be right at 2.5 inches wide and 3 inches tall.

view full answer...

Answer 3

Installation hardware is not included with the Swivel D Ring part #RR06 due to the unknown nature of the surface that the end user will attach it to. Depending on the weight of the object that will be held down, and the thickness of the surface it…

view full answer...

Answer 4

I pulled the Brophy Trailer D-Ring Tie Down, #RR06, from my warehouse to measure and verified that the diameter of the flange is in fact 6-5/16 inches. I also verified that all other measurements on the product page are correct. I have attached the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

What Size Mounting Hardware is Required to Install the Trailer D-Ring Tie Down, # RR06

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching