Battery Temp Monitor on Go Power Industrial Pure Sine Wave Inverter Charger
Updated 06/29/2021 | Published 06/25/2021
Question:
if you connect the go power 3000 IC to a lithium Ion Batt do you need to attach the battery monitor that is supplied with the 3000 IC? or is that just for lead acid battery applications?
asked by: Scott
Expert Reply:
If you are referring to the battery temp monitor on the Go Power Industrial Pure Sine Wave Inverter Charger, # 34275013, then yes you should. The temperature sensor installs to the negative battery terminal then connects to the battery temperature port on the inverter charger. This inverter should be installed near the battery bank but not in the same compartment.
Product Page this Question was Asked From
Go Power Industrial Pure Sine Wave Inverter Charger - 3,000 Watts - 100 Amps - 12V
- RV Power Inverter
- Pure Sine Wave
- Air Conditioner
- 12V
- 3000 Watts
- Inverter/Charger/Transfer Switch
- AGM/Gel/Lead Acid
- Lithium
- Power Center
- Go Power
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Dimensions Unlimited Inverter Charger on Winnebago Tour
- Q&A: Parts Needed to Connect Go Power PowerTrak Screen, Inverter, and Solar Charge Controller
- Q&A: Is Pre-Charge Resistor Needed When Installing Rich Solar NOVA 3k12
- Q&A: What Cables are Needed for Adding a Second Solar Charge Controller to a Go Power System?
- Q&A: Progressive Dynamics 2000 Watt Inverter Try To Charge Batteries
- Q&A: Inverter Recommendation for Running a Single AC Unit
- Article: Trailer Wiring Diagrams
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Article: 4 Common Myths About RV Solar Power
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How Much Solar Power Do I Need For My RV?
- Article: Must-Have Flat Towing Components
- Article: What Is a Supplemental Braking System?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today