Correct Hydraulic Brake Assembly for Dexter 8-201 Hub/Drum
Updated 04/13/2013 | Published 04/10/2013
Products Featured in This Question
Question:
I pulled a tire off my boat trailer and found stamped on it dexter 8-201 I think this part i am looking at is the right brake assemble for that hub Looking for your input before purchasing Also is this a marine application if not what would u recommend
asked by: Steve P
Helpful Expert Reply:
The Dexter 8-201 is a common 12 x 2 inch hub/drum used on 5,200 or 6,000 lb capacity axles. The 23-324 left hand hydraulic brake assembly you mentioned would certainly be compatible. You would also need the right hand assembly, part # 23-325.
For a marine application, I would recommend the Demco 12x2 Marine Hydraulic Brake Assembly, part # 23510 for the right side, and # 23511 for the left. These brake assemblies feature galvanized backing plates and stainless steel spring hardware.
Product Page this Question was Asked From
Dexter Hydraulic Drum Brake Assembly - Uni-Servo - 12" - Left Hand - 5,200 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- 5200 lbs
- Brake Assembly
- Single Servo
- 12 x 2 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Looking For Replacement Cover For MaxxFan 4700G Roof Vent
- Q&A: Comparing Dexter and etrailer.com 7,000 Pound Electric Brake Assemblies
- Q&A: Comparing Single and Dual Servo Hydraulic Drum Trailer Brakes
- Q&A: What are the Dimensions of Trailer Jack Support Plate # BD003135
- Q&A: Replacement Hub for Tie Down Engineering 11033
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Q&A: Wiring Diagram for the Bulldog Powered-Drive Kit # BD1824200100
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure for Trailer Hitch Drop