How To Confirm Fit of Kodiak Disc Brake Kit
Updated 06/02/2021 | Published 06/01/2021
Question:
Hello my boat trailer currently has drum brakes T1544500042 would I be able to switch to this disc brake set and not have any problems? I just get the bearings listed to fit this and it would work?
asked by: Rob M
0
Expert Reply:
The Kodiak Disc Brake Kit part # K2HR2D is designed for 2,000 lb axles which use L44649 bearings. Therefore, so long as these are the bearings your axle uses, you have a four bolt mounting flange, and wheels between 10-13" then it will fit.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 8" Rotor/Hub - 5 on 4-1/2 - Dacromet - 2,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 2000 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Disc Brake Hubs, Lines, and Hydraulic Actuator for a Boat Trailer w/a 3,500 lbs Axle
- Q&A: Steps To Determine Correct Replacement Bearing Kit for 2005 Karavan BW-2350-74-ST Boat Trailer
- Q&A: Are there Brakes for a 8" Wheel?
- Q&A: Stainless Steel Disc Brake Kit Compatible with Magic Tilt Trailer
- Q&A: Will 8 Inch Rims Fit With The AxleTek 7" x 1 1/4" Electric Brake Assembly
- Q&A: Installing Brake Lines For Disc Brake Kit On Single Axle Boat Trailer
- Q&A: Brake Flange that Can Fit to Square Axle that is 1.5 inches by 1.5 inches
- Article: Ram Trailer Tow Prep Package
- Article: Trailer Lighting Requirements
- Article: How to Bleed Your Trailer Surge Brakes