Is the Reese POD Brake Controller Supposed to Light Up with Brakes Applied and No Trailer Attached
Updated 05/26/2021 | Published 05/21/2021
Question:
Does light on Reese POD controller supposed to come on when brake applied when no trailer hooked up?
asked by: Kyle
Expert Reply:
I spoke with Reese about your POD controller.
When you apply the brakes with no trailer hooked up, the light will flash red briefly. It should turn off shortly.
However, if it stays on, then there may be a problem with the blue wire. Trace this wire to look for frays or corrosion. If you see any, you will need to replace it. Problems with this wire will "trick" the controller into believing that there is a trailer hooked up.
You might also test your 7-way with a circuit tester like part # PTW2993 to make sure everything is working properly there.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Brake Controller Installation: Starting from Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Q&A: Troubleshooting Blown Vehicle Fuses Every Time Trailer is Connected
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer