bing tracking image
Q & A Icon

Troubleshooting Arms on Roadmaster Falcon 2 Not Locking Into Place  

Updated 06/26/2026 | Published 05/17/2021

Question:

Most of the time when I hookup only one arm locks. So then I turn in the direction of the locked arm and still does not lock. Actually the distance on the unlocked arm gets shorter. I wind trying to get the car even on both sides so when I pull forward they both lock. I have seen other people with a Falcon 2 being able to pull forward and both arms lock. And if my memory serves me right when I first started using it I would just pull forward and both arms would lock. What do I need to do?

0

Expert Reply:

Your memory does serve you right and both arms on your Roadmaster Falcon 2 # RM-520 are designed to "lock up" as this is not a non-binding tow bar; whether or not they've been able to get the arms to lock without performing the two sharp turns I don't know to be true. With that said, since you're going through the setup procedure that would normally cause the arms to lock, it would appear your bar might be damaged.

I recommend using the Complete Repair Kit for Roadmaster Falcon 2 and BlackHawk Tow Bars # RM-910003-60, which will replace all of the replaceable small and moving parts on your Falcon 2 tow bar and should get everything back to working order.

The only other alternative, would be replacing it with another # RM-520.

expert reply by:
0
Erik B
Michael G. profile picture

Michael G.

6/26/2026

I believe my issue is the same as Paul. I can pull the one arm out and it will lock but with just a little force it pushes back in. Like Paul, when I drive the one arm goes in and the other stays locked and extended. Does the repair kit include a new bullet and spring?

Robin H. profile picture
Etrailer Expert

Robin H.

6/26/2026

@MichaelG the # RM-910003-60 includes the following: 2 Autowlok buttons 2 Button stems 2 Springs 2 Pins 1 Epoxy glue kit 2 Collar shoulder bolts (2) 3/4" Nuts 2 Nylock nuts 2 Square black end caps (9) 1-1/2" Diameter acetyl washers (2) 1-1/4" Diameter acetyl inner arm bushings (4) 3/4" Diameter acetyl washers 2 Nylatron outer arm bushings

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>