Does Replacement Spine for Yakima HoldUp Bike Rack # 8890277 Come with Threaded Pin Nut

Question

Question:

It looks like this is shown both with and without the nut retainer installed. Does it come with it or would I need to also order Y90254?

asked by: NATE C

0

Expert Reply:

The Replacement Spine for Yakima HoldUp Bike Rack # 8890277 does come with the threaded insert that the hitch pin would thread into.

expert reply by: Jameson C

0

Answer 1

Hi Mike, I know exactly what you’re looking for, and I get why you want to make sure you get the right part so your HoldUp stays usable. We don’t currently carry the gray 888-0127 spline anymore, but the replacement spine part #8890277 is the same…

view full answer...

Answer 2

For your Yakima HoldUp 2 Bike Rack for 1-1/4" Hitches - Platform Style - Tilting #Y02445, the Replacement 2" Hitch Adapter for Yakima Carriers #Y8890174 will not work according to my contact at Yakima and it is no longer available. Instead…

view full answer...

Answer 3

What comes with the Yakima Replacement Spine Assembly part #8890277 that you referenced is what you see in the product picture that I attached. You would need to reuse the installation hardware from your current rack to install this on your Yakima…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Does Replacement Spine for Yakima HoldUp Bike Rack # 8890277 Come with Threaded Pin Nut

Product Page this Question was Asked From

Continue Researching