How to Remove Crank Handle on Sidewind DL-3400 Jack
Updated 05/07/2021 | Published 05/06/2021
Question:
How do you remove the broken handle on DL 3400 1200 lb. sidewind jack handle?
asked by: Steven J
0
Expert Reply:
We actually put together a short video on repairing a similar jack that will show you how to access and remove the old crank and replace it with the # MJ-1500B-HD. Your DL-3400 should have a screw at the top that is holding the end cap on; you'll want to remove that screw and then look for the pin holding the handle to the upper gear- the video does a good job of illustrating this around the 4:50 mark.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Replacement Sidewind Handle for etrailer and Ram Swivel Marine Jacks - 1,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Sidewind Gear Kit for a Bulldog 190754 Jack
- Q&A: Determining Correct Grease Seal and Axle Capacity on Vintage Trailer
- Q&A: Handle Diameter and Length to Fit etrailer.com Sidewind Jack Handle with Haul Master Trailer Jack
- Q&A: Recommended Hitch for a 2023 Lexus RX 350
- Q&A: Using # 37185 Adapter to Provide 7-Way Trailer Connector on 2003 Ford Pickup
- Q&A: Replacement Hubs for a Triton 08351 PWC Trailer Axle
- Q&A: Can I Install the Square A-Frame Jack w/ Footplate e74VV in a Round A-Frame Hole?
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Maintenance Schedule
- Article: How Much Solar Power Do I Need For My RV?