Trailer Jack with Wheel that Fits Same Pipe Mount as Bulldog Jack
Updated 05/04/2021 | Published 05/01/2021
Products Featured in This Question
Question:
HI, I have a snap ring jack on my shorelandr trailer. it is only mounted via snap ring as the mount is integrated into the boat winch and tongue. It is a bulldog static 3000 lb jack and 2000 lift capacity jack but has a flat plate on the bottom. I am looking for same with a wheel on the bottom and there is not a pin on the bottom to replace the flat plate with a wheel. I suspect a whole new jack but am limited to a snap ring placement, no compression bolts with a plate behind it. What options do you have? thanks,
asked by: Eric P
Expert Reply:
Since Fulton and Bulldog jacks fit the same size snap rings and since Bulldog doesn't offer a similar jack that has a wheel caster your best solution is the Fulton part # FTJ120W0301 which would fit the same snap ring and comes with a wheel caster.
Product Page this Question was Asked From
Bulldog Round, Snap-Ring Swivel Jack - Sidewind - 15-1/4" Lift - 2,000 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 1001 - 2000 lbs
- Manual Jack
- 15 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Video: Complete Breakdown of the Fulton Boat Trailer Jack w/ Wheel
- Q&A: Do Bulldog and Fulton Trailer Jacks Use Same Snap Ring Dimensions
- Q&A: Snap Ring Swivel Jack for a Trailer that Already has a Jack Mount
- Q&A: Replacement Trailer Jack for Bulldog Jack with Wheel and Side Handle
- Q&A: Swivel Trailer Jack that Can Fit on 2-1/2 inch Diameter Pipe Mount
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Shop: Pull Pin, Easy Swivel Trailer Jack with Foot - Sidewind - 10" Travel - 2,000 lbs
- Shop: Bulldog Round Jack without mount - Sidewind - 10" Lift - 2,000 lbs
- Shop: Bulldog Bolt-Thru Swivel Trailer Jack - Bolt On - Sidewind - 10" Lift - 1,500 lbs - Gray
- Shop: Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Shop: Replacement Bearing for etrailer and Ram Round, Topwind Jacks - 2,000 lbs and 5,000 lbs
- Shop: Replacement Thrust Bearing Kit for Bulldog Trailer Jacks - 2,000-lb Capacity
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Q&A: Replacement For Bulldog Swivel Trailer Jack With 2-1/2 Inch Mounting Bracket
- Article: Determining Trailer Tongue Weight
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Jacks
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Article: Anti-Rattle Devices
- Article: Calculating Portable Generator Power Needs